Panels Plus Squaring Table

This machine is designed to tack Sheathing to wall panels made from 2x4 to 2x10, dimensional and engineered lumber. The wall panel is rolled into the Squaring table from the Framer or buffer station and clamped to ensure the wall panel is square.

General Specifications:

The following dimensions are approximate and are provided only to give the foot print of the machine. Additional space is required for material storage and handling.

Machine Length20’-6”
Machine Width8’-4”
Table Height33”
Wall Lengthup to 16’-0
Wall Height4’-0” – 12’-4”
Electrical120Vac/60Hz/15amp
AirN/A

Squaring Table: The walk through open table design consisting of a stationary and moveable section. The moveable section traverses in and out on v-tracks mounted on the floor. The table can be opened or closed to set the wall height, or clamp and unclamp the wall by simply stepping on a footswitch located on the load end of the table or pressing the open or close buttons located on the exit end of the table. The wall panel is rolled in and out of the table on roller conveyors.

Up

Panels Plus Squaring Table w/Manual Router Bridge

This machine is designed for routing the Sheathing around window and door openings on wall panels made from 2x4 to 2x10, dimensional and engineered lumber. The wall panel is rolled into the routing station from the Framer and clamped to ensure the wall panel is square. The sheathing can then be applied to the wall and tacked in place. The operator then uses the bridge to cut the sheathing around the window and door openings.

General Specifications:

The following dimensions are approximate and are provided only to give the foot print of the machine. Additional space is required for material storage and handling.

Machine Length22’-0”
Machine Width20’-6”
Machine Height8’-4”
Table Height33”
Wall Lengthup to 16’-0
Wall Height4’-0” – 12’-4”
Max Wall & Sheathing Thickness12.5”
Electrical120Vac/60Hz/15amp
Air10 CFM @ 90-120psig

Squaring Table: The walk through open table design consisting of a stationary and moveable section. The moveable section traverses in and out on v-tracks mounted on the floor. The table can be opened or closed to set the wall height, or clamp and unclamp the wall by simply stepping on a footswitch located on the load end of the table or pressing the open or close buttons located on the exit end of the table. The wall panel is rolled in and out of the table on roller conveyors.

Router Bridge: Manual X-Y Bridge is operated with cranks. Bridge has a pendant to drive the bridge into position and automatically return to its home position when finished.

Call us for custom-sized builds