Panels Plus Tilt Table
This machine is designed to tilt the wall panel from lying flat to 75 degrees to allow the operator to work on the bottom side of the wall. The wall panel is rolled into the table and clamped to ensure the wall panel cannot come out when in the tilted position.
General Specifications:
The following dimensions are approximate and are provided only to give the foot print of the machine. Additional space is required for material storage and handling.
| Machine Length | 18’-2” |
| Machine Width | 12’-6” |
| Table Height | 33” |
| Wall Length | up to 16’-0 |
| Wall Height | 6’-8” – 12’-4” |
| Electrical | 120Vac/60Hz/15amp |
| Air | 15CFM @ 90-120 psig |